Table of Contents
Advertisement
UART Mode Select
Select an operating mode for the second serial port:
S
a t
n
d
a
d r
r I
D
A
A
S
K
I
R
UART2 Duplex Mode
This setting allows the COM port to receive and transmit data simultaneously.
Default is at half duplex.
RxD, TxD Active
This setting is reserved and should be left as default. Default setting is Hi, Lo
IR Transmission delay
Adjust this setting to set the delay before a signal is sent through the IR port.
Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical
parallel port.
Onboard Parallel Mode
This option allows the user to select a mode for the onboard parallel port.
ECP Mode Use DMA
Allows the parallel ports to enable DMA, this a faster transfer rate.
EPP Mode Select
This setting selects the printer port's data transfer mode.
PWRON After PWR-Fail
This function enables the computer to power up or down after a sudden power
interruption. If the setting is set to OFF, the computer will stay off even if the
power is resumed. If it is set to On, the computer will power on when power is
restored. If the setting is set to Former-Sts, the computer will return to the
previous state before the power was interrupted.
S1834 Tiger 133
R
S
2 -
3
2
C
s
r e
l a i
p
o
t r
S
r e
a i
i l
f n
a r
e r
d
p
o
t r
A
m
p
i l
u t
d
e
h s
t f i
k
e
e y
d
i
f n
a r
e r
d
p
o
t r
51
Hide quick links:
Advertisement
Table of Contents
