TYAN THUNDER K7 User Manual page 49

We recommend that you keep your Ultra160 and Ultra2 SCSI devices on a sepa-
NOTE: rate SCSI channel from your Ultra SCSI devices. This allows the newer Ultra160
and Ultra2 SCSI devices to transfer data at their maximum speed.
1
Step
Locate a 68-pin internal LVD SCSI cable, which may have either twisted wires or flat wires,
as shown here.
Terminated end
Plug the non-terminated end of the cable(s) to the LVD/SE SCSI connector(s) (shown below).
2
Step
Plug the internal Ultra160 and Ultra2 SCSI devices to the other cable connectors, starting
3
Step
with the connector at the terminated end of the cable (note: example installation below may
not identically represent installation).
Terminator device
Internal Ultra160 SCSI peripherals come from the factory without termination. Proper
NOTE: termination is provided by the built-in terminator at the end of the Ultra160 internal
SCSI cable.
Thunder K7 S2462
Non-terminated end
49