Assembling And Attaching Brass Trim - Desa Comfort Glow CGF265NVA Owner's Operation And Installation Manual

INSTALLING
Continued
10

ASSEMBLING AND ATTACHING BRASS TRIM

Note: The instructions below show assembling and attaching brass trim to fireplace.
Do not yet install trim if performing a built-in installation (see page 14, Built-
In Fireplace Installation)
1. Remove packaging from three pieces of brass trim.
2. Locate four brass screws, two adjusting plates with set screws, and two shims
in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 5.
4. Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim
(see Figure 5).
5. Slide other end of adjusting plate/shim in slot on mitered edge of side brass
trim (see Figure 5).
6. While firmly holding edges of brass trim together, tighten both set screws on
the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
Side Brass Trim
Figure 5 - Assembling Brass Trim
8. Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets.
Place the assembled trim onto fireplace cabinet. Align hanging notches on
trim with hanging screws on side of fireplace (see Figure 6). Push trim firmly
into place, sliding hanging notches over hanging screws.
Assembled
Brass Trim
Figure 6 - Attaching Brass Trim to Fireplace
Set Screws
Adjusting
Plate
Shim
Mitered Edge
Slot
Top Brass Trim
Slot
Trim Hanging
Screws
Hanging
Notches on
Trim
102664