Operating Fireplace (Thermostat-Controlled Model) - Desa Comfort Glow CGF265NVA Owner's Operation And Installation Manual

INSTALLING
Continued
OPERATING
FIREPLACE
Thermostat-
Controlled Model
CGF280NT
102664
You must operate this fireplace with the fireplace screen in place.
Make sure fireplace screen is in place before running fireplace.
5. Install fireplace screen by slipping notches of fireplace screen over screws on
front of fireplace (see Figure 24).
Notches
Figure 24 - Installing Fireplace Screen
FOR YOUR SAFETY READ BEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell
next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the
knob will not push in or turn by hand, don't try to repair it, call a qualified service
technician or gas supplier. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water. Immediately call a
qualified service technician to inspect the appliance and to replace any part of the
control system and any gas control which has been under water.
WARNING
WARNING ICON G 001
WARNING
WARNING ICON G 001
Screws for
Mounting
Screen
Continued
21