Assembling Heater - Desa Comfort Glow RFP28TC Owner's Operation And Installation Manual

VENT-FREE RADIANT FLAME
ASSEMBLY

ASSEMBLING HEATER

Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom cor-
ners of front panel with Phillips screw-
driver.
2. Pull bottom of front panel forward, then
down (see Figure 2) .
Figure 2 - Removing Front Panel of Heater
Installing Log
Note: For easier installation, lay heater on
its back.
1. Remove log from inside top of heater.
Discard protective packaging.
2. Attach ignitor cable to piezo ignitor
(see Figure 3).
3. With Phillips screwdriver, remove four
screws holding screen in place. Re-
move screen.
4. Gently slide log between log retaining
brackets on deflector assembly (see Fig-
ure 4). The log should fit firmly against
bottom of log retaining brackets.
5. Reattach screen using four screws re-
moved in step 3.
Piezo Ignitor
Ignitor Cable
Figure 3 - Attaching Ignitor Cable to Piezo
Ignitor
WARNING: Always have
burner shield and screen in place
before operating heater. This pre-
vents excessive temperatures on
heater surfaces.
Failure to position the parts in
accordance with these diagrams
or failure to use only parts spe-
cifically approved with this heater
may result in property damage or
personal injury.
Log
Screen
Front Panel
Truss Head
Screw
Brass
Front Trim
Figure 4 - Assembling Heater
4
®
HEATER
Attaching Brass Front Trim to
Front Panel
1. Locate brass front trim in brass trim
package.
2. Slide the head of two truss-head screws
from hardware packet into each end of
brass front trim (see Figure 5).
3. Line up screws with holes in front panel
(see Figure 4). Insert screws in holes.
Attach nuts from inside of front panel.
Tighten with wrench.
Brass Front
Trim
Truss-Head
Screw
Figure 5 - Attaching Brass Front Trim to
Front Panel
Nut
Screw
Front Panel
Nut
Heater Cabinet
Deflector
Log
Retaining
Brackets
Burner Shield
Screw
103509