Desa Comfort Glow CGF265NVA Owner's Operation And Installation Manual page 12

INSTALLING
Continued
12
2. Break off nailing flanges (see Figure 8) with hammer or pliers.
3. Place mantel and base in desired location. Place heater in front opening of
mantel. Make sure all pieces fit properly. Remove mantel.
4. Mark floor and base or wall for gas line entrance. Make sure there is enough
clearance between heater and mantel for gas line. IMPORTANT: Make sure
there are no electrical lines where gas piping will go through floor or wall.
5. Cut an access hole in hearth base top to run flexible gas line to fireplace (see
Figure 9). Make sure to locate access hole so cabinet mantel will cover it when
installed. Note: You can secure base to floor using wood screws. Countersink
screw heads and putty over.
Figure 8 - Location of Nailing Flanges
6. Install gas piping to fireplace location. This installation includes an approved
flexible gas line (if allowed by local codes) after the manual shutoff valve. The
flexible gas line must be the last item installed on the gas piping. See Installing
Gas Piping to Fireplace Location, page 16.
Hearth Base
Figure 9 - Placing Hearth Base Accessory Against Wall
Flexible Gas Line
Nailing Flanges
Electrical Outlet
Gas Line Access
Hole
102664