Cleaning And Maintenance; Troubleshooting - Desa Comfort Glow CGF265NVA Owner's Operation And Installation Manual

CLEANING
AND
MAINTENANCE
TROUBLE-
SHOOTING
Note: All troubleshooting
items are listed in order of
operation.
102664
Turn off fireplace and let cool before cleaning.
You must keep control areas, burners, and circulating air pas-
sageways of fireplace clean. Inspect these areas of fireplace
before each use. Have fireplace inspected yearly by a qualified
service person. Fireplace may need more frequent cleaning due to
excessive lint from carpeting, bedding material, etc.
ODS/PILOT AND BURNERS
• Use a vacuum cleaner or small, soft bristled brush to clean.
LOGS
• If you remove logs for cleaning, refer to Installing Logs, pages 20 and 21, to
properly replace logs.
• Replace log(s) if broken or chipped (dime-sized or larger).
Turn off fireplace and let cool before servicing. Only a qualified
service person should service and repair fireplace.
Never use a wire, needle, or similar object to clean ODS/pilot. This
can damage ODS/pilot unit.
POSSIBLE
OBSERVED
CAUSE
PROBLEM
1. Ignitor cable pinched or
When ignitor button
is pressed, there is no
spark at ODS/pilot
2. Ignitor electrode not con-
3. Piezo ignitor nut is loose
4. Broken ignitor cable
5. Ignitor electrode broken
6. Bad piezo ignitor
7. Ignitor electrode posi-
WARNING
WARNING ICON G 001
CAUTION
WARNING ICON G 001
WARNING
WARNING ICON G 001
CAUTION
WARNING ICON G 001
wet
nected to ignitor cable
tioned wrong
REMEDY
1. Free ignitor cable if
pinched by any metal or
tubing. Keep ignitor
cable dry
2. Reconnect ignitor cable
3. Tighten nut holding
piezo ignitor to base
panel of log set. Nut is
located behind base
panel.
4. Replace ignitor cable
5. Replace ignitor
6. Replace piezo ignitor
7. Replace ignitor
Continued
27