Adjustments - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
8.5
This section describes the electrical adjustments of the equipment as the
adjustment procedures to be carried out by service persons at the time
of installation.
Tuning adjustments, bearing adjustments, and range adjustments can be performed from
the keyboard.
The following procedure must be used to enter the equipment into adjustment mode:
Procedures
８
EXIT

ADJUSTMENTS

Do not carry out the adjustments of the equipment except authorized
service persons. Otherwise, an accident or trouble may result.
Do not carry out the adjustments during navigation. Otherwise, the radar
performance may be affected, resulting in an accident or trouble.
1 Click MENU on the screen. Or press OPTION2 key.
The MAIN Menu will appear.
2 Click CODE INPUT .
The CODE INPUT Menu will appear.
3 Click 0 , then END .
The ADJUST Menu will appear.
1 Click EXIT .
The ADJUST Menu will be closed.
2 Click EXIT .
The CODE INPUT Menu will be closed.
3 Click EXIT .
The TEST Menu will be closed.
CAUTION
8-33
ADJUST
1.TUNE
0-127 1.5
2.BEARING
0.0-359.9゜ 000.0
3.CPA RING
0-999 10
4.ANTENNA HEIGH
3.OVER 25m
ARPA/AIS
5.
SECTOR BLANK
6.
MBS
7.
EXIT
０．