Measurement Between Two Optional Points - JRC JMA-9922-6XA Instruction Manual

• œ • œ • œ • œ • œ • œ • œ • œ • œ
Measurement between Two Optional Points¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
Procedures
1.
2. Left-click the C switch at the lower right of the EBL2.
3.
4.
5. Press
6. Using the trackball, move the VRM2 marker on a dotted-line of
EBL2 to the point B.
• œ • œ • œ • œ • œ • œ • œ • œ • œ • œ
Press to select EBL2 display and operation.
EBL2
The "EBL2" indication at the lower right of the radar display will be selected and
the EBL2 will appear as a dotted-line on the PPI display.
Using the trackball, move the starting point of EBL2 to one
(A) of the two points.
(See Fig. 4.3.)
Turn the [EBL] control to move EBL2 to the other point (B).
(See Fig. 4.3.)
VRM2
to select VRM2 display and operation.
(● VRM marker) will appear on a dotted-line of the EBL2.
The VRM2 marker ● moves away from the center of the display by turning the
trackball clockwise, and closer to the center.
The bearing and range between the two points will appear in the "VRM2" and
"EBL2" area on the lower right of the radar display.
4-4
• œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ • œ
‚ S