Programming User Codes - NAPCO XP-400 Using Instruction

Your Installer has assigned a User 1 Code which may be used to not only Arm and Disarm the system, but
also to enter the User Program Mode, where you can program and/or reprogram up to 4 User Codes. The
following explains how you will use this code to program or erase additional user codes.

Entering the User Program Mode
Press
will flash, and the keypad will beep 4 times. You are now in the User Program mode.
ARMED
Zone lights 1 through 4 will light to indicate any User Codes presently programmed.
READY
SYSTEM
Programming / Reprogramming User Codes
1
Press the User number to be programmed. (For example, press
The keypad will beep 2 times and the corresponding Zone light will flash to indicate the user
number you are about to program.
2
Press in the 4 digits of the new User 2 code, the keypad will beep 4 times.
ZONE 1 3
If there are more user codes to be programmed, return to step 1 above, otherwise, go to Exiting the
ZONE 2 User Program Mode below.
ZONE 3
Erasing a User Code
ZONE 4
1
Press the User number to be erased. The keypad will beep 2 times and the corresponding Zone light
will flash to indicate the user number you are about to erase.
2
Press
3
If there are more user codes to be erased, return to step 1 above, otherwise, go to Exiting the user
Program Mode below.
Exiting the User Program Mode
When you are done programming or erasing User codes, press
Oi220a
page 11

followed by and then enter the User 1 code. The Armed, Status and

. The zone light will go out to indicate that the user code has been erased.

Programming User Codes

System Lights
to program the User 2 code.).

to Exit the User Program Mode.
Tuesday, September 16, 1997 08:30
11