Programming User Codes - NAPCO XP-600 Express Series User Manual

Programming User Codes

Your Installer has assigned a User 1 Code which may be used to not only Arm and Disarm the system, but
also to enter the User Program Mode, where you can program other user codes. The following explains how
you will use this code to program or erase additional user codes.
Entering the User Program Mode
ARMED
READY
SYSTEM
Programming / Reprogramming User Codes
FIRE
AC
ZONE 1
ZONE 2
ZONE 3
Erasing a User Code
ZONE 4
ZONE 5
ZONE 6
Exiting the User Program Mode
14
 
Press followed by
flash, and the keypad will beep 4 times. You are now in the User Program mode. Zone lights 1 through 6
will light to indicate any User Codes presently programmed.
1
Press the User number to be programmed. (For example, press
The keypad will beep 2 times and the corresponding Zone light will flash to indicate the user
number you are about to program.
2
Press in the 4 digits of the new User 2 code, the keypad will beep 4 times.
3
If there are more user codes to be programmed, return to step 1 above, otherwise, go to Exiting the
User Program Mode below.

1
Press the User number to be erased. The keypad will beep 2 times and the corresponding Zone light
will flash to indicate the user number you are about to erase.
2
Press . The zone light will go out to indicate that the user code has been erased.
3
If there are more user codes to be erased, return to step 1 above, otherwise, go to Exiting the user
Program Mode below.
When you are done programming or erasing User codes, press
and then enter the User 1 code. The Armed, Status and
9
System Lights will
to program the User 2 code.).
"
to Exit the User Program Mode.