IBM THINKPAD T60 - SERVICE AND Service And Troubleshooting Manual page 24

Solving computer problems
Message
Cannot boot from
any device.
If one of the following error code messages is displayed on the screen, have the
computer serviced:
0175: Bad CRC1, stop POST task
0177: Bad SVP data, stop POST task. Checksum of the supervisor password in the
EEPROM is not correct.
0187: EAIA data access error
0188: Invalid RFID serialization information area
0189: Invalid RFID configuration information area
0192: System Security - Embedded Security hardware tamper detected.
0260: System timer error
0270: Real time clock error
02D0: System cache error
02F4: EISA CMOS not writable
02F5: DMA test failed
02F6: Software NMI failed
02F7: Fail-safe timer NMI failed
Fan error
Thermal sensing error
16
®
ThinkPad T60 Service and Troubleshooting Guide
Solution
Check the status of the device which you want to boot from.
Device not found
Check the device you want to boot from.
No valid operating system
Check that the operating system has no failure and is
installed correctly.
Excluded from boot order
Open the BIOS Setup Utility and add the device to boot
order.