Closing The Nas Appliance; Inside The Nas Appliance - Dell PowerVault NX3600 Owner's Manual

Figure 14. Opening and Closing the NAS Appliance
1. screws (4)
2. NAS appliance cover

Closing The NAS Appliance

NOTE: This is a service only procedure.
1. Offset the cover toward the front of the NAS appliance.
2. Align the notches on the edges of the chassis with the cover alignment pins on the inner sides of the cover.
3. Place the cover onto the chassis and offset the cover slightly to the front so that the cover lays flush with the
chassis.
4. Slide the cover toward the back of the system so that the screw holes on the cover align with the screw holes on
the NAS appliance chassis.
5. Using the Torx 8 screwdriver, replace the screws to secure the cover on the NAS appliance chassis.
6. Connect the power cable(s) to the power supply units and plug the power cable(s) into a power outlet.

Inside The NAS Appliance

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE: Components that are hot-swappable are marked orange and touch points on the components are marked
blue.
24