Start Iscsi Dhcp Refresh - Dell PowerVault MD3220 Cli Manual

Parameter
Parameter
enclosure

Start iSCSI DHCP Refresh

This command initiates a refresh of the DHCP parameters for the iSCSI
interface. If the configuration method for the interface is not set to DHCP ,
the procedure returns an error.
Syntax
start controller [(0 | 1)] iscsiHostPort [(1 | 2 |
3 | 4)] dhcpRefresh
Parameters
Parameter
controller The identifier letter of the RAID controller module that has the
iscsi-
host-port
NOTE:
This operation ends the iSCSI connections for the portal and brings down
the portal temporarily.
250
Script Commands
Description
iSCSI host ports. Valid RAID controller module identifier values are
0 or 1, where, 0 is the RAID controller module in slot 0, and 1 is the
RAID controller module in slot 1.
The identifier of the port on the storage array on which you want to
refresh the DHCP parameters. Enclose the iSCSI host port name in
([ ]).
square brackets
Description
Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.