Set Host - Dell PowerVault MD3220 Cli Manual

Parameters
Parameter
physicalDisk or
physicalDisks
allPhysicalDisks

Set Host

This command assigns a host to a host group or moves a host to a different
host group. You can also create a new host group and assign the host to the
new host group with this command. The actions performed by this command
depend on whether the host has individual mappings or does not have
individual mappings.
Syntax
set host [hostName]
hostGroup=("hostGroupName" | none | defaultGroup)
userLabel="newHostName"
hostType=(hostTypeIndexLabel |
hostTypeIndexNumber)
Parameters
Parameter Description
The name of the host that you want to assign to a host group.
host
Enclose the host name in square brackets ([ ]). If the host name has
special characters, you must also enclose the host name in double
quotation marks (" ").
The host group to which you want to assign the host. (The following
hostGroup
table defines how the command runs if the host does or does not
have individual virtual disk-to-LUN mappings.) Enclose the host
group name in double quotation marks (" "). The defaultGroup is
the host group that contains the host to which the virtual disk is
mapped.
Description
The tray and the slot where the physical disk
resides. Tray ID values are 0 to 99. Slot ID values
are 0 to 31. Enclose the tray ID values and the
slot ID values in square brackets ([ ]).
Selects all the physical disks.
Script Commands
191