Replacing The Needle; Thread Cutter - Bernina Bernette 25 Instruction Manual

16 Machine Setup

Replacing the Needle

Thread Cutter

B
A
502020.75.28_021H2D0101_1010_IM_bernette 20 25_EN
Attention:
Turn power switch to off ("O") when carrying
out the below operation!
Change the needle regularly, especially if it
is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle. The flat side of the shaft should
be towards the back.
B. Insert the needle as far up as it will go.
Needles must be in perfect condition.
Problems can occur with:
- Bent needles
- Blunt needles
- Damaged points
The thread cutter serves two purposes.
1. Cut the thread after threading the needle
2. Cut the thread after finishing a seam.
To cut the thread after completing your work
raise the presser foot.
Remove the fabric, draw the threads to the
left side of the face cover and cut using the
thread cutter.
The threads are cut at the proper length to
start the next seam.