Outdoor Leisure TD100A Owner's Manual page 6

ASSEMbLy
Continued
BURNER AND LIGHTPOST ASSEMBLY
1. Locate 4 lightpost panels that are pack-
aged together. Assemble  of the pieces
with 4 screws (H) as shown in Figure 5.
2. Place lightpost top over panel assembly
aligning screw holes. Attach with  screws
(H) as shown in Figure 5.
. Pilot light and wiring has been placed
inside top of burner assembly for ship-
ping. Carefully remove pilot from inside
assembly and let wiring and pilot hang
down back of assembly.
4. Place pilot assembly on top of lightpost
top as shown in Figure 6. Attach with
4 screws (H). Check wire connections
before proceeding.
5. Place lightpost panels and top assembly
on top of burner assembly aligning back
side of each assembly. See Figure 6. At-
tach with  screws (H).
6. Attach 4 light shroud screens to light
shrouds with 4 screws (F) and 4 nuts (G)
each as shown in Figure 7. Only 2 of the
4 screens are shown.
7. Place deco light shrouds on top of light-
post top (see Figure 7). Make sure flanges
are on top. Slide shroud tabs together.
Attach to lightpost top with 4 screws (H)
through holes in bottom of shroud pieces
(see Figure 7). Tighten all screws.
8. Attach lightpost top cap to shroud assembly
with 4 screws (H) as shown in Figure 7.
Screw (H)
Lightpost
Top
Lightpost
Panels
Screw (H)
Figure 5 - Lightpost Panels and Top
Assembly
6
Pilot
Assembly
Lightpost
Assembly
Screw (H)
Burner
Assembly
Figure 6 - Connecting Lightpost and
Screw (H)
Screw (H)
Lightpost
Top
Figure 7 - Attaching Pilot and Shroud
www.desatech.com
Burner Assembly
Nut (G)
Screen
Screw (F)
Screw
(H)
Open Side
of Panel
Assembly
to Back of
Heater
Pilot Light
Wiring to
Back of
Heater
Lightpost
Top Cap
Deco
Light
Shroud
Fourth
Lightpost
Panel
122527-01B