Assembly - Outdoor Leisure TD100A Owner's Manual

Estimated assembly time: 45 minutes
Tools required:
• #2 Phillips screwdriver
• 1/2", 5/16" and 7/32" Open end wrenches
Hardware packet provided with heater may
contain more parts than needed for heater

assembly.

Hardware packet contains the following items
shown on pages 10 through 1:
Electronic Ignitor (1), Ignitor Wire (1), Ground
Wire (1), Valve Knob (1), Propane Tank Reten-
tion Chain (1), Retention Hook (2), D Batteries (2)
and AA Battery (1).
Parts are referenced by designated letter
throughout assembly instructions. Hardware
packet contains the following (quantity used
in parenthesis):
BASE ASSEMBLY
1. Connect 2 base parts using 5 screws (C),
5 washers (D) and 5 nuts (E) as shown in
Figure 3.
2. Turn base upside down. Attach 2 wheels,
2 hex bolts (A) and 2 nuts (B) as shown
in Figure 3. Do not overtighten.
. Being careful not to scratch paint, lay
cabinet base onto back side (use foam
packaging block to support rear top of
cabinet base). Align holes in bottom
edges of cabinet base with holes in base
as shown in Figure 4. Attach with 1 screw
Base
Nut (E)
Washer (D)
Screw (C)
Figure 3 - Attaching Wheels to Base
122527-01B
ASSEMbLy
Wheel
Hex Bolt (A)
Nut (B)
www.desatech.com
Description
A 2 / " Hex Bolt (2)
1
4
B 12 mm Hex Nut (2)
C 5/8" Screw (14)
D 5 mm Washer (14)
E 5/16" Hex Nut (14)
F 3/8" Screw (20)
G 7/32" Hex Nut (20)
H 3/8" Self tapping screw (34)
A
B
C
(C), 1 washer (D) and 1 nut (E) for each of
the 9 holes (see Figure 4). Set assembly
upright.
4. Install chain retainers ("S" hooks) to up-
per edges of cabinet base as shown in
Figure 4.
5. Install electronic ignitor through cabinet
wall as shown in Figure 4. Hand tighten.
6. Attach tank door to cabinet with 4 screws
(F) and 4 nuts (G) as shown in Figure 4.
Set entire assembly aside.
Chain
Cabinet Retainer
Base
Nut (G)
Screw (F)
Screw
(C)
Washer
(D)
Tank
Door
Base
Nut (E)
Figure 4 - Cabinet Base Assembly
Part No.
HC4-18C
NPC-5C
119619-03
119600-02
NPC-3C
119619-06
NPC-1C
119620-02
G
D
E
H
F
Retainer
Ignitor
Ring
Ignitor
Cap
5