Operator Log - Kodak i1840 User Manual

Operator Log

3-30
Image Address information
• Level buttons — when image addressing is enabled, the three image
address level buttons will be displayed: Level 3, Level 2 and Level 1.
You can increment the image address level by touching one of the
level buttons. During a scan session the level button that is
highlighted is the level which will be assigned to the next document.
• Next Image Address — the values displayed in the level buttons
indicate the image address which will be assigned to the next
document.
Scroll arrows — touch the up or down scroll arrow to display additional
functions that are not currently visible on the touchscreen.
Settings button — displays the Settings screen where you can set the
volume, change the language, set the tone and enable or disable image
addressing.
When you touch Operator Log, the Operator Log screen will be
displayed. This screen provides the time, message code and a
message description.
The messages that are displayed in the log are only those messages
that have been posted since the scanner was powered on. When you
turn the power off, the Operator Log on the Operator Control Panel
touchscreen will be cleared.
To view messages which have been cleared from the Operator Control
Panel touchscreen, see Chapter 6, Troubleshooting.
• To clear the operator log, touch Clear.
• After viewing the operator log, touch Close to return to the Idle
screen.
A-61555 May 2010