Replacement Procedures; Replacing The Feed Module Or Feed Module Tires - Kodak i1840 User Manual

Replacement
procedures
Replacing the feed module
or feed module tires
A-61555 May 2010
This section provides procedures for replacing the following parts. Use
the list below as a guideline for frequency of replacement.
• Feed module tires and separation roller tires — tire life will vary
depending upon paper types, environment and cleanliness. Nominal
tire life is approximately 600,000 documents; results will vary.
Degradation of feeder performance, multiple feeds, stoppages, etc.
indicate a need to change tires. Change all the tires on the feed
module and separation roller at the same time.
• Feed module and separation roller — it is recommended that you
install a new feed module and separation roller approximately every
4th tire change. Install a new feed module and separation roller at the
same time.
• Pre-separation pad — it is recommended that you change the pre-
separation pad at least as often as you change the feed module/
separation roller tires.
• Imaging guides — replace when the imaging guides are heavily
scratched and defects show in the image.
1. Remove the output tray.
2. Lift up the printer access cover.
3. Open the pod.
5-15