Maintenance And Services - Konica Minolta DR1600 Operator's Manual

MAINTENANCE AND SERVICES

■ MAINTENANCE AND SERVICES
1. Replacing the Illumination Lamp
When the ends of a fluorescent lamp turn black, it indicates that the lamp needs replacement. To ensure even
illumination over the entire surface of the Copy Board, replace the old lamp with a new one.
NOTE
The two fluorescent lamps should be replaced at once. Use FL-15W (white) for the fluorescent lamp.
27
1
Turn OFF the Power ON/OFF Switch.
CAUTION
Be careful, the fluorescent lamp is very hot to touch
immediately after the machine has been turned OFF.
Wait for about five minutes until they cool down.
2
Rotate the lamp, removing it from the sockets.
3
Install a new lamp by reversing the order of removal.