Electronic Ignition; Cooling System - GAS GAS EC - 2005 Service Manual

Hide thumbs Also See for EC - 2005:
Table of Contents

Advertisement

ELECTRONIC IGNITION

This motorcycle uses a capacitor discharge ignition system (CDI).
The ignition system should never require adjustment unless the
stator of the magnetic flywheel was incorrectly installed during engine
reassembly.
If necessary, inspect and adjust as follows:
Adjustment
- Remove the magnetic flywheel cover (A).
- Verify that the mark (C) on the magnetic flywheel is aligned
with the mark on the crankcase (B).
(A)
125 cc.
200/250/300 cc.
(B) (C)
EC / MC / SM 2005 -
- If the marks are not aligned, loosen the magnetic inertia wheel
screws and turn it.
- Tighten the screws securely.
- Install the magnetic flywheel cover.
NOTE
Engine tune-up can be adjusted to match the rider´s preferences
and skills.
- Remove the magnetic flywheel cover.
- Loosen the stator screws.
- Adjust the engine tune-up by changing the position of the stator
within prudent limits
NOTE
For the best engine performance, it is very important to adjust
the engine tune-up within the set of limits described.
- Tighten the stator screws.
- Install the magnetic flywheel cover.
- Test ride the motorcycle and readjust the engine tune-up, if
necessary.

COOLING SYSTEM

Radiator Hoses
Check the radiator hoses for cuts or deterioration, and the connections
for looseness and leaks.
Radiator
Check the radiator fins for obstructions (insects or mud). Remove
any obstructions with a stream of low water pressure.
82
-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents