Steering Blockage - GAS GAS EC - 2005 Service Manual

Hide thumbs Also See for EC - 2005:
Table of Contents

Advertisement

To check the steering adjustment use a stand under the chassis,
and lift the motorcycle off the ground. Move the handlebar lightly to
either side; if the handlebar continues moving under its own
momentum, the steering is not too tight. Squatting in front of the
motorcycle, grasp the lower end of the front fork (at the axle), and
push and pull the fork (as shown on the previous photo); if free play
is felt, the steering is too loose.
If the steering needs adjustment
- Use a stand or a special support to stabilize the motorcycle.
- Raise the front wheel off the ground.
- Remove the handlebar (A) by loosening the handlebar holder
screws and removing the upper holders.
(A)
(D)
- Loosen the steering stem nut (B).
- Loosen the screws of the suspension top bridge (C) and remove
it.
- Turn the steering adjustment nut with the special wrench to obtain
the proper adjustment.
(C)
(B)
EC / MC / SM 2005 -
- Install the suspension top bridge (D).
- Tighten the steering stem nut, and front fork washers and screws.
Steering nut: 44 Nm (4,5 Kgm).
Suspension top bridge: 22 Nm (2,25 Kgm).
- Check the steering again, and readjust if necessary.
- Install the removed parts.

STEERING BLOCKAGE

As indicated by its name, this mechanism allows us to lock the
handlebar. Is located in the steering pipe.
You have to turn the handlebar completely to the right, next insert
the key, turn left, press, turn right and remove the key.
95-
(A)
(A). Steering lock.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents