15 TUNING THE ENGINE
15.6
15.7
Switching the ignition timing map from Performance to Soft
–
Switching the ignition timing map from Soft to Performance
–
15.8
15.9
100
Plug-in connector of ignition timing map adjustment
Changing the ignition timing map
1
Disconnect plug-in connector
Soft – better rideability
1
Join plug-in connector
of the ignition timing map adjustment. (Figure S04566-10
Performance – better performance
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
Adjusting the basic position of the shift lever
1
Plug-in connector
on the frame under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map adjustment
•
is disconnected to achieve better rideability.
Performance – The plug-in connector of the ignition timing map
•
adjustment is joined to achieve higher performance.
S04566-10
of the ignition timing map adjustment. (Figure S04566-10
–
Sit on the vehicle in the riding position and determine distance
between the upper edge of your boot and the shift lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
1
Remove screw
401950-12
of the ignition timing map adjustment is located
p. 100)
p. 100)
10 ... 20 mm (0.39 ... 0.79 in)
with the washers and take off shift lever
A
(
p. 100)
2
.