Setting The Digital In Assignment; Setting The Video Input Mode - Denon AVR-1706 Operating Instructions Manual

Advanced Setup

Setting the Digital In Assignment

This setting assigns the digital input terminals of the AVR-1706
for the different input sources.
1
CURSOR F F G G
Press the or button to assign the
input function connected to the COAXIAL 1
ENTER
input terminal, then press the
H H
button to switch the COAXIAL 2 input setting.
2
CURSOR F F G G
Press the or button to assign the
input function connected to the COAXIAL 2
ENTER
input terminal, then press the
H H
button to switch the OPTICAL 1 input setting.
3
CURSOR F F G G
Press the or button to assign the
input function connected to the OPTICAL 1
ENTER
input terminal, then press the
H H
button to switch the OPTICAL 2 input setting.
4
CURSOR F F G G
Press the or button to assign the
input function connected to the OPTICAL 2
ENTER
input terminal, then press the
H H
button to switch the Video Input Mode setting.
• Select "OFF" if nothing is connected.
• "TUNER" and "V. AUX" cannot be selected.

Setting the Video Input Mode

CURSOR
or
Select the input signal to be output to the composite S-Video and
component monitor output terminals using the video conversion
function.
1
CURSOR F F
Press the
video input mode, then press the
CURSOR H H
button to switch the input source
(TV) setting.
CURSOR
or
2 CURSOR F F
Press the
video input mode, then press the
CURSOR H H
button to switch the input source
(VCR) setting.
CURSOR
or
3 CURSOR F F
Press the
video input mode, then press the
CURSOR H H
button to switch the Audio Delay
setting.
CURSOR
or
Auto:
Component:
G G
or button to select the
S-Video:
ENTER
or
Video:
G G
or button to select the
ENTER
or
• Down-converting from the component video signal to the S-
G G
or button to select the
ENTER
or
42
ENGLISH
When there are multiple input signals, the input signals are
detected and the input signal to be output from the video
monitor output terminal is selected automatically in the
following order: component video, S-Video, composite video.
The signal connected to the component video terminal is
always played.
Video conversion is not conducted, so no image is output
from the monitor output terminal when there is no input
signal to the component terminal.
The signal connected to the S-Video terminal is always played.
The S-Video input signal is converted and output from the
composite and component monitor output terminal.
The signal connected to the composite video terminal is
always played.
The composite video input signal is up-converted and output
from the S-Video and component monitor output terminals.
Video and composite video signal is not possible, so when not
using the component video monitor output terminal connect
the player using the S-Video or composite video input terminal
( page 11).
ENGLISH
Advanced Setup