Placing Originals; Placing Originals On The Original Table - Ricoh Aficio MP W3600 Operating Instructions Manual

Placing Originals

Placing Originals
This section describes the procedure for placing originals on the original table.
1
Important
❒ Set one original at a time on the original table.
❒ Once an original start to feed in, do not push or pull it. This may damage the
original.
❒ If the original's rear edge is badly curled, smooth it out with both hands be-
fore scanning. If the original is inserted as is, it may be damaged.
❒ When inserting an original, push it lightly against the rollers. Pushing it with
force may cause an original jam.
❒ When inserting an original, be careful not to put the trailing edge into the en-
trance of the bypass tray. This will cause an original jam.
Note
❒ Place originals after any correction fluid or ink has completely dried. Not taking
this precaution will result in a dirtied exposure glass and blemished copies.
❒ Dust and residue from originals drawn with a pencil can result in a dirtied ex-
posure glass and blemished copies. We recommend using the carrier sheet for
this type of original.

Placing Originals on the Original Table

Place originals on the original table.
A
Make sure "
B
Adjust the original guides to the size and orientation of the original.
Make sure the original guides are flush against the original. Do not push the
original guide side fence with force.
20
" appears on the screen.
Ready
ATY068S