Quick Select Function; Personal Memory Plus Function; Last Function Memory; Backup Memory - Denon AVR-488 Owner's Manual

Quick Select Function

With this function, the currently playing input source, input mode,
surround mode and volume can be stored in the memory.
1
Set the input source, input mode, surround mode and
volume to the conditions you want to store.
2
QUICK SELECT>
Press and hold <
appears on the display.
[Quick Select Defaults]
Input Source
Quick Select 1 DVD/HDP
TV/CBL
Quick Select 2
Quick Select 3 VCR
To call out the settings, press <QUICK SELECT> at which the desired
settings were stored.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode, etc.)
last selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control and the volumes of the different
speakers are stored for the individual surround modes.

Last Function Memory

This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
until "Memory"

Backup Memory

The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
Volume
–40 dB

Resetting the Microprocessor

–40 dB
–40 dB
Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
Turn off the power using
2
<POWER>
Press
<SPEAKER A>
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
<POWER>
.
while simultaneously pressing
<SPEAKER B>
and .
ENGLISH