Denon AVR-1905 Operating Instructions Manual page 40

ENGLISH
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the direct mode.
1 The tone switches as follows each time the TONE CONTROL
button is pressed.
TONE
CONTROL
(Main unit)
2 With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)
• To decrease the bass or treble: Turn the control
counterclockwise. (The bass or treble sound can be
decreased to up to –12 dB in steps of 2 dB.)
[2] Listening over headphones
1 Plug the headphones' plug into the jack.
Connect the headphones to the
PHONES jack.
The pre-out output (including the
speaker output) is automatically
turned off when headphones are
connected.
[3] Turning the sound off temporarily (muting)
1 Use this to turn off the audio output
temporarily.
Press the MUTING button.
Cancelling MUTING mode.
• Press the MUTING button again.
• Muting will also be cancelled
when MASTER VOL is adjusted
up or down.
[4] Combining the currently playing sound with the desired image
1 Simulcast playback
Use this switch to monitor a video source
other than the audio source.
Press the VIDEO SELECT button repeatedly
until the desired source appears on the
display.
Cancelling simulcast playback.
• Select "SOURCE" using the video
select button.
• Switch the program source to the
component connected to the video
input jacks.
40
BASS TREBLE
SELECT
(Main unit)
PHONES
1
VIDEO SELECT
(Main unit)
(Remote control unit)
3 If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
TONE
DEFEAT
(Main unit)
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
1
Display
IN=V SOURCE
2 3 1
The signals do not pass through the
bass and treble adjustment circuits,
so it provides higher quality sound.
1
1 1