Denon AVR-1905 Operating Instructions Manual page 29

Power Amp Assignment
Setting the power amplifier assignment
• Make this setting to switch the power amplifier for the surround back channel to ZONE2.
• If ZONE2 is selected, the signal that selected at ZONE2 is output at "SURR. BACK/ZONE2" PREOUT terminals.
1
2
Setting the On Screen Display (OSD)
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
• Sets the on-screen display's display mode.
Mode 1: Prevents flickering of the on-screen display when there is no video signal.
Mode 2: Flickering is not prevented.
Use this mode if the on-screen display does not appear in the mode 1, as may happen according to the TV being used.
1
2
3
Select "Surround Back" to use as the surround back channel,
"Zone2" to use as Zone 2 out.
26 AMP
Press the ENTER or (down) button to switch the On Screen Display setting.
Select "ON" or "OFF".
27 OSD
Select the On Screen Display Mode.
Select the "MODE1" or "MODE2".
Press the ENTER or (down) button to switch the Auto Preset Memory setting.
S.BACK
ON
28 OSD MODE1
ENGLISH
29