Replacing Light Bulbs - Toyota CAMRY 2007 Owner's Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The high mounted stoplight consists of a
number of LEDs. If any of the LEDs burn
out, take your vehicle to your Toyota deal-
er to have the light replaced.
CAUTION
D
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
400
'07Camry_U (L/O 0601)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
if
Light bulbs
Headlights
(high)
Headlights (low)
like the
Front side
marker lights
Front turn
contact your
signal/parking
lights
Rear turn signal
lights
Stop/tail and
rear side
marker lights
Tail lights
(type A)
Tail lights
(type B)
License plate
lights
Back−up lights
Front fog lights
Front personal
lights
2007 CAMRY from Jan. '06 Prod. (OM33669U)
Bulb
W Type
No.
9005 60 A
— 55 B
— 5 C
3457NAK 30/8 D
— 21 D
7443 21/5 C
— 5 C
194 3.8 C
— 5 C
921 16 C
— 55 B
— 5 C