Presetting A Station; Selecting A Station - Toyota CAMRY 2007 Owner's Manual

AUDIO SYSTEM
Turn the knob clockwise to step up the sta-
tion band or counterclockwise to step
down.
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. "ST" appears on the screen. If the
signal becomes weak, the radio reduces the
amount of channel separation to prevent the
weak signal from creating noise. If the signal
becomes extremely weak, the radio switches
from stereo to mono reception. In this case,
"ST" disappears from the screen.
156

Presetting a station

1. Tune in the desired station.
2. Touch one of the channel selector but-
tons (1 — 6) you want and hold it until a
beep is heard.
This sets the station to the touch−screen but-
ton and the frequency appears on the touch−
screen button.
Each radio mode can store up to 6 stations.
To change the preset station to a different
one, follow the same procedure.
The preset station memory is cancelled when
the power source is interrupted by battery dis-
connection or a blown fuse.

Selecting a station

Tune in the desired station using one of the
following methods.
Preset tuning: Touch the channel selector
button (1 — 6) for the station you want. The
touch−screen button is highlighted and the
station frequency appears on the screen.
Seek tuning: Push the " " or "
"SEEK·TRACK". The radio will begin seek-
ing up or down for a station of the nearest fre-
quency and will stop on reception. Each time
you push the button, the stations will be
searched automatically one after another.
To scan all the frequencies: Touch "SCAN"
on the screen or push the "SCAN" button
briefly. "SCAN" appears on the screen. The
radio will find the next station and stay there
for a few seconds, and then scan again. To
select a station, touch "SCAN" or push the
"SCAN" button again.
To scan the preset stations: Touch
"SCAN" on the screen or push the "SCAN"
button for longer than approximately a sec-
ond. "P·SCAN" appears on the screen. The
radio will tune in the next preset station, stay
there for a few seconds, and then move to the
next preset station. To select a station, touch
"SCAN" or push the "SCAN" button again.
" button of