Alarms - GE Security DIGIA II User Manual

Alarms

Figure 9 shows the Alarms submenu.
Figure 9. Alarms
Table 5. Alarms submenu
Menu item
Alarm #
Alarm
Alarm frame rate
Quality level
Alarm duration
Sensor type
Event buzzer
Alarm to full screen
Email notification
Video loss
Motion detection
Motion sensitivity
Motion detection grid
Digia II Menu - Alarms
<< Alarm 1
Alarm
Alarm Frame Rate
Quality Level
Alarm Duration
Sensor Type
Event Buzzer
Alarm to Full Screen
eMail Notification
Video Loss
Motion Detection
Motion Sensitivity
Select EXPORT to Copy Settings
Select DISPLAY to Paste Settings
Description
The current alarm being edited.
Choose between Disable, Enable, and Global.
Choose between off, 1, 2, 3, 4, 5, 6, 7.5, 10, 20, and 30 fps.
Choose between 1-lowest, 2, 3, 4, 5, and 6-highest.
Choose between 1 and 60 seconds.
Choose between NC, NO, NC Trans, and NO Trans.
Check this box if you want to hear an alarm buzzer.
Check this box if you want the video to become full screen when the
alarm is triggered.
Check this box if you want the Digia II to send an e-mail to a
predetermined e-mail address when the alarm is triggered.
Check this box if you want this alarm triggered when video is lost.
Choose between Disable, Partial, and Full. If you set it to partial, it will take
you into the motion detection grid.
Choose between 1-lowest, 2, 3, 4, 5, 6, 7, 8, and 9-highest.
Use the directional arrows to move the highlight square to a desired area.
Enter toggles the cells on or off. When a cell is on, that area will be
monitored for motion detection.
>>
Disable
10 f/s
6-Highest
05 Sec(s)
NC
Disable
7
Chapter 3 15
Setup