Lexicon OMEGA - MANUAL 2 Owner's Manual page 22

Recording Multiple Channels At One Time - Section I
5. Turn Omega's Monitor Mix control all the way to Direct, since you're not over-
6. Now let's start recording. Click on the
7. Turn the Omega's Monitor Mix control clockwise to the Playback position. Now press
D. RECORDING FROM S/PDIF
2 gain knob. Now let's set the level of the keyboard and the guitar. On the front of the
Omega make sure the
Now play some loud notes on the keyboard and bring the level up on line 4 until you
are near clipping. Strum some chords of the guitar and bring up the line 3 gain until
you are just below clipping.
dubbing. Adjust headphone level with the Output Level control. Mic 1 and the guitar
will be in the left headphone, and Mic 2 and the keyboard will be in the right. If you
would rather hear everything in the center, press the Monitor switches (beneath the
USB Assign switches) in to the Mono position. But resist the temptation to turn down
levels on the front of the Omega to get a headphone mix – Levels have been properly
adjusted for the best signal-to-noise ratio on the tracks.
on Cubase's Transport Control. Speak or
BUTTON
play an instrument into the microphone. When you are
finished recording press the
Cubase's
PLAYBACK
Adjust the overall listening volume with the Output level knob, and the playback
levels and pan positions of individual tracks with Cubase's Mixer window.
One of the key features of the Lexicon Omega Studio is its ability to monitor S/PDIF
in real time with no latency. This allows you to record directly from a device with the
S/PDIF digital output and listen while you are recording. S/PDIF is a digital signal
that carries a stereo signal on a single cable for left and right.
22
button is in the
METER ASSIGN
RECORD
STOP BUTTON
button to listen back to the tracks you have just recorded.
V
position (Button is in).
3-4
.