Lexicon OMEGA - MANUAL 2 Owner's Manual page 20

Recording Guitar Into The Instrument Jack - Section I
3. Open Cubase, go to
4. Next, we need to adjust the input gain
5. Now let's start recording. Click on the
C. RECORDING MULTIPLE CHANNELS AT ONE TIME
, , and a project location.
PROJECT DEFAULT
To add an audio track, right click in the dark
gray column and select Add Audio Track. In
the Add Audio Track dialog, set the configura-
tion to Mono and click OK. Now, let's set the
input of the track so we can record from the 1-2
USB assign. Click on the
button so that it's lit. You will now see
the Track Inspector window to the left. Click
on the
LEFT - STEREO IN:
for the track input source.
STEREO IN > LEFT
Next, click on the
RECORD ENABLE
button so that it is red. Click on the
MONITORING
not lit.
of the instrument input on the front of the Omega
make sure the
METER ASSIGN
1-2 position (button is out). Now strum the guitar
while gradually turning up the
you are seeing its Peak light come on occasion-
ally. Now check the meter on the front of the Omega
to make sure you are not clipping.
on the Transport control. Play some
BUTTON
chords or notes on the guitar. When you are finished
recording press
STOP
Now press the
PLAYBACK
recorded.
The above is just one possible routing. With the Omega Studio and Cubase, remember
that you can record from any input to any track (or even to multiple tracks at
once). Line 3 of the Omega can travel to Cubase via USB bus 1 or USB bus 3, and
be recorded onto Cubase tracks 1, 2, 3, 4, 5...any track when STEREO IN > LEFT
or STEREO IN 2 > LEFT (depending on which USB bus Line 3 is assigned to) is
selected as the track input source.
In this example we will record two microphones, a guitar and a keyboard
into the Omega all at one time.
20
and select
FILE NEW
SHOW INSPECTOR
box and select
INPUT
button so that it is
button is in the
Gain until
LINE 3
RECORD
and Rewind .
button to listen back to the track you have just