System Mode Parameters - Lexicon MPX 200 - REV 1 Manual

System Mode
Note:
System parameters are automatically saved with
each change. Changes you make to these con-
trols are applied immediately (except for Global
Compressor Mode) and remain in that state until
changed again.
To exit System Mode, press & hold Bypass again for
approximately two seconds. The display will
flash "Sto" to verify that any changes you made
have been stored.
Note:
The System Parameter Mix Mode is identified on
the 3-digit display as "d-p."
wondered: "Why such a cryptic name?
does it mean?" Think of "d-p" as short for "dry-
processed." This name was chosen because a 7-
segment digit cannot display either "m" or "x,"
which would have been the logical choices.
Hence a name was chosen that would be dis-
tinctive from other System Parameter names.
3-2
Some users have
What

SYSTEM MODE PARAMETERS

1. Output Level
2. Input Source
3. Digital
Output
4. Global Mix
Mode
5. Bypass Mode
6. Program
Load
7. Global Tempo
Mode (Tap)
8. Global
Compressor Mode Global
9. Patching
* designates default value
Lexicon, Inc.
0 dB - Off
Analog* or Digital
(S/PDIF)
Dry or Processed*
Program* or Global
Mute All/Quiet (qui),
Input Mute (inp), or
Bypass (dry)*
Mute or Bypass*
Program*or
Global
Program* or
Off or On*