Table of Contents
Advertisement
MPX 200
REAR PANEL DETAILS AND USAGE
Power
Uses a detachable IEC power
cable. Use the correct cable
for receptacles in your area.
100-120/220-240V~
50 - 60Hz, 25W
Line Voltage Switch
Located on the side
of the unit.
IMPORTANT!
Be sure to select the
appropriate voltage
for your area to avoid
damage to the unit.
MIDI IN and OUT/THRU
The MPX 200 is shipped with the System
parameter for MIDI OUT/THRU set to OUT.
To change this to a MIDI THRU port, change
the System parameter to THRU.
MIDI
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOC
ELECTRIQUE
NE PAS OUVRIR
FOOTSWITCH
IN
T-TAP
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK DO NOT EXPOSE
R-BYP
THIS UNIT TO RAIN OR MOISTURE
S-GND
FOOTSWITCH
A momentary-contact footswitch.
Tip - Tempo
Ring - Bypass
Sleeve - Ground
Tip
Sleeve
Tip
Ring
Sleeve
Ring
Bypass
The footswitch jack requires a Tip/Ring/Sleeve 1/4-inch plug. The Tip
controls Tempo similar to the Tap button and the Ring controls Bypass
similar to the Bypass button. A handy mnemonic to remember is: "Tip
for Tempo; Ring for Reverb." You cannot use an "unbalanced" Tip/
Sleeve plug for the footswitch because the MPX 200 will detect this
as if the Bypass button were being pressed.
Powering-up the MPX 200 with a Tip/Sleeve plug inserted into the
footswitch jack will cause it to enter Diagnostic Mode. If this occurs,
turn the MPX 200 off, remove the plug, and turn it on again.
44.1K S/PDIF
PROFESSIONAL
AUDIO EQUIPMENT
IN
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference; and
OUT / THRU
OUT
(2) this device must accept any interference received,
including interference that may cause undesired operation.
S/PDIF
Digital
Input and Output
Tap
Getting Started
OUTPUT
L & R 1/4-inch Unbalanced Outputs. If no cable is
plugged into the L Output, the R Output provides
a mono signal of both channels. If no cable is
plugged into the R Output, the L Output can
drive a set of stereo headphones.
OUTPUT
LISTED
8B25
LEFT
RIGHT
(PHONES)
(MONO)
INPUT
L & R 1/4-inch Unbalanced Inputs.
If no cable is plugged into the L Input,
the R Input feeds a mono signal to
both channels.
INPUT
LEFT
RIGHT
(MONO)
1-3
Advertisement
Table of Contents
