Lexicon MPX 200 - REV 1 Manual page 28

MPX 200
10. MIDI Channel
11. MIDI Pgm
Change
12. MIDI Clock
Receive
13. MIDI
OUT/THRU
14. Autoload
15. Dump
User Bank
16. Dump Current
Program
17. Dump
System
18. Clear
User Bank
19. Initialize
* designates default value
Off, Channels 1 -16,
All (Omni)
Off or On*
Off or On*
Out* or Thru
Off* or On
Press Store to execute
Press Store to execute
Press Store to execute
Press Store to execute
1. Output Level: This is the first parameter that you
will see when entering the System Mode. It adjusts
the overall output level of the MPX 200 from 0dB
(maximum) down to Off.
2. Input Source: Here you select either the Analog or
Digital (S/PDIF) input. If you select Digital In and
no digital signal is present, the MPX 200 will mute.
Note:
When the Input Source is set to Digital and the
MPX 200 is in either Load mode or Edit mode, the
display will show a message for four seconds
whenever it detects any change in the S/PDIF
input status. For example, if you remove the input
cable while it is connected and receiving a valid
44.1k S/PDIF signal, the display will show
"nod" for "no digital".
re-acquires a digital
"dig".
System Mode
Whenever it
signal, it will show
continued on next page . . .
3-3