Table of Contents
Advertisement
THE ADJUST KNOB
The Adjust knob is located on the right side of the front
panel and performs multiple functions. For example:
A. When the Load button is pressed,
the Adjust knob is used to select
the programs.
B.
When the Edit button is pressed,
the Adjust knob is used to control
one of the Edit functions.
To reassign the Adjust knob for selecting Programs, press
the Load button.
Other functions are described throughout this manual.
SELECTING AND LOADING PROGRAMS
The MPX 200 contains 240 presets and storage for 64 User
Programs.
To select a Preset or User Program as the
running program:
1.
Press the Load button. (Omit this step if you are
already in Program Load mode.)
2.
Turn the Adjust knob until your desired program
number appears on the display, or effects and
routing are indicated by the EFFECTS and ROUT-
ING LEDs.
3.
Press Load again to load your selected program.
The program can also be set to load automati-
cally. (See Autoload on page 3-3 / item 14).
Your loaded program number is displayed in the
3-digit display. The LEDs for the selected
program will light to indicate which effects the
selected
program
program contains a dual effect, the appropriate
ROUTING LED will light.
The compressor will always be available in any program,
and is situated in front of any other effect for the
"wet" component signal path. If compression is
included in that program, the COMPRESSOR effect LED
lights even though the compressor can always be turned
on or off (using the Compressor button). Thus, the EFFECTS
display shows what would run if that program were
Load
loaded.
Basic Operation
contains.
If
the
2
ROUTING (DUAL
C
C
C
C
selected
Compressor
2-1
Advertisement
Table of Contents
