Automating The Pc-90 - Lexicon LDI 12T User Manual

Lexicon Studio T System User Guide

Automating the PC-90

The PC-90 Digital Reverberator can be completely automated within any control software that
supports automation. Refer to the user guide for your particular software package for support offered
for this functionality. The following section describes PC-90 automation within Cubase VST.
To write enable the channel that PC-90 is assigned to, open the Cubase VST Mixer window and click
the Write button.
Changes made to PC-90 parameters will be recorded to an Audio Mix Part. Any changes (even those
made while the transport is in Stop) are recorded, as long as the Write button is enabled.
If you check the Arrange window after you stop playback, you will note that a special Mixer Track called
Audiomix has been created. This Track contains one long Part named Audiomix, in which all your
Monitor mixer actions are stored. Don't worry about the length of this Part — it will automatically be
lengthened if you record past its end.
Please note that there is only one Audiomix Part/Track, created the first time you use the Write
function in your Arrangement. No new Parts are created the next time you use the Write function —
information is added to the existing Part.
To stop writing automation events, click the Write button a second time, or close the Mixer window.
All changes to this track and its plug-ins will cease to record.
Using the PC-90
39
39