Rear Panel Connections; Typical Configurations - Lexicon LDI 12T User Manual

Installation

Rear Panel Connections

Two (2) optical TOSLINK™ connectors for input/output connection to 8-channel ADAT-compatible
format OR 2-channel Optical S/PDIF format
Two (2) ADAT sync D9 connectors
One (1) Word Clock input BNC connector (75 ohm termination)
One (1) Serial D9 connector
One (1) Power connection
One (1) Multi-pin computer connector
NOTE: The BNC Word Clock Input has a 75 ohm termination. Therefore, if you are distributing Word

Typical Configurations

Following are some typical LDI-12T configurations. These are provided as a starting point, and to
familiarize you with the possibilities your system provides. Once your system is physically configured,
signal routing is controlled by the Lexicon Studio Driver and the routing provided by your host
application program (Cubase VST, for example). Use of the Lexicon Studio Driver and examples of
typical host application routing is covered in the next section, Signal Routing .
12
12
ADAT ADAT or S/PDIF
AUDIO
SYNC IN SYNC OUT
In
Clock to a chain of devices, the LDI-12T must be last in the chain.
Out
COMPUTER
WORD CLOCK IN
RS-422 POWER
Lexicon