Convenience Features; Using Vfo-B - Yaesu FT-950 Operating Manual

VFO-B operates similar to VFO-A, which you should be
familiar with by now. However, the [ CLAR/VFO-B ] knob,
instead of the Main Tuning Dial knob selects the frequency
for VFO-B (See box below for tuning rate). The two VFOs
make simple transmit/receive split frequency operation
possible. Use various combinations of the four VFO red
and green transmit and receive switches to set up split fre-
quency operation. The [ SPLIT ] button also sets up split
frequency operation. See page 69 for details about Split-
Frequency Operation
The frequency and mode data can be transferred from VFO-
A to VFO-B by pressing the [ A B ] button, don't forget
that this will overwrite any settings that were in VFO-B
previously. Also, the contents of the two VFOs can be
swapped (with no loss of data) by pressing the [ A B ]
button.
Most of the interference reduction features, which are de-
scribed later, can also be used on VFO-B.
Two things you cannot do with VFO-B that you can do
with VFO-A, are store the contents of VFO-B directly into
a memory, and set the Clarifier offset. For these functions
you need to swap the VFO-B with the VFO-A by pressing
the [ A B ] button, then store the contents into the memory
or set the Clarifier.
[ CLAR/VFO-B ] K
O M 1
PERATING ODE STEP
N
ORMAL
LSB/USB/CW/AM/ 10 Hz
RTTY/PKT ( LSB ) [ 100 Hz ]
FM/PKT ( FM ) 100 Hz [ 1 kHz ]
[ ] : [ FAST ] switch set to "ON"
A :
DVICE
It is possible to set the frequency change over one dial
rotation, separately for the CW mode, using the Menu items
"084 TUN DIALSTP 084 TUN DIALSTP" and "085 TUN CW FINE
084 TUN DIALSTP 084 TUN DIALSTP 084 TUN DIALSTP
page 116.
FT-950 O
PERATING
U
SING THE
T R
NOB UNING ATE
1
DIAL ROTATION
[ F ] [ F ]
N
AST ORMAL AST
2 kHz
[ 20 kHz ]
20 kHz [ 200 kHz ]
085 TUN CW FINE". See
085 TUN CW FINE 085 TUN CW FINE 085 TUN CW FINE
M
ANUAL
C
ONVENIENCE
VFO-B
F
EATURES
Main Tuning Dial Knob
[ A B ] Button
[ SPLIT ] Button [ CLAR/VFO-B ] Knob
[ A B ] Button
Page 35