Convenience Features; Band Stack Operation; Custom Switch ) - Yaesu FT-991A Operating Manual

The FT-991A utilizes a triple band-stack VFO selection technique that permits storing of up to three favorite frequen-
cies and modes onto each band VFO register. For example, one frequency each on 14 MHz CW, RTTY, and USB may
be stored and then recalled by successive, momentary touches of [ 14 ] on the screen displayed by the BAND button.
Each Amateur band key may similarly have up to three frequency/mode settings applied. Note that only the VFO-A sys-
tem has the band stacks.
A typical setup, for the 14 MHz band, might be arranged like this:
1. Program 14.025 MHz, CW Mode, then press the
BAND button, and then touch [ 14 ] on the LCD.
2. Program 14.080 MHz, RTTY Mode, then press the
BAND button, and then touch [ 14 ] on the LCD.
3. Program 14.195 MHz, SSB Mode, then press the
BAND button, and then touch [ 14 ] on the LCD.
To individually recall each of the three stored operating
states, press the BAND button, and then touch [ 14 ] on
the screen repeatedly.
【BAND】【14】
【BAND】【14】
Advice:
The 5MHz band stack may be recalled by touching and holding [ 14 ] on the LCD in a similar operation.
The front panel C.S button may be programmed to directly access an often-used Menu Mode selection.
C.S Setup
1. Press the MENU button to engage the Menu mode;
the Menu list will appear on the display.
2. Rotate the MULTI knob to select the Menu item you
want to access with the front panel C.S button.
3. Press the C.S button to lock in your selection.
4. Press the MENU button or touch [ BACK ] on the
LCD to save the new configuration and exit to nor-
mal operation.
Menu Selection Recall via C.S button
Press the C.S button.
The programmed Menu item will appear on the display.
Press the MENU button or touch [ BACK ] on the LCD
exit to normal operation.
FT- 991 Operating Manual

Convenience Features

Band Stack Operation

【BAND】【14】
C.S ( Custom Switch )
BAND Button
MENU button C.S button
MULTI Knob
Page 39