Memory Scan - Yaesu FT-2000 Operating Manual

VFO
AND
1. Set the transceiver up in the memory mode by pressing
the [ V/M ] button, if necessary.
2. Rotate the Main [ SQL ] knob so that the background
noise is just silenced.
3. Press the [ M CH ] button momentarily.
When you press the [ M CH ] button, the Red LED im-
bedded within the switch should light up, indicating
that you are ready to choose a channel into which to
store the data.
A :
If the Red LED imbedded in the [ M CH ] button does
not light up, check to be sure that the orange lamp to
the right of the [ SUB VFO-B ] knob is not illuminated.
If it is, press the [ A/B ] button to make it go out, then
press the [ M CH ] button again.
4. Press and hold in the microphone's [ UP ] or [ DWN ]
key for 1/2 second to start scanning in the specified
direction.
A :
If the scanner halts on an incoming signal, the deci-
mal point between the "MHz" and "kHz" digits of
the frequency display will blink.
If the incoming signal disappears, scanning will re-
sume in about five seconds.
5. To cancel the scanning, press the microphone's [ UP ]
or [ DWN ] key momentarily.
A :
During Memory Group operation, only the channels
within the current Memory Group will be scanned.
If the scan has paused on a signal, pressing the
microphone's [ UP ] or [ DWN ] key will cause scanning
to resume instantly.
If you press the microphone's PTT switch during scan-
ning, the scanner will halt at once. Pressing the PTT
switch during scanning will not cause transmission,
however.
You may select the manner in which the scanner re-
sumes while it has paused on a signal, using Menu item
"039 GEnE SCN RSM." The default "5Sec" setting
will cause the scanner to resume scanning after five
seconds; you may change it, however, to resume only
after the carrier has dropped out, if you like See page
119.
Page 106
M S
EMORY
M
EMORY
CANNING
S
CAN
Main [ SQL ] Knob
Q P :
If you have no interest in scanning, and wish to prohibit
the microphone's [ UP ] / [ DWN ] keys from initiating scan-
ning, you may disable scanning control from the micro-
phone using Menu item "038 GEnE MIC SCN" (set it to
"Off").
FT-2000D O
[ V/M ] Button [ A/B ] Button
[ SUB VFO-B ] Knob
[ M CH ] Button
M