Front Panel Controls & Switches; Power Switch - Yaesu FT-2000 Operating Manual

F P
RONT ANEL

POWER Switch

Press and hold in this switch for one second to turn the
transceiver on. Similarly, press and hold in this switch
for one second to turn the transceiver off. (The FP-
2000's [ POWER ] switch must also be set to on "I"
before this switch will function.)
A :
The main power switch for the system is located
on the front panel of the FP-2000 Power Supply.
When the FP-2000 main power switch is pushed
down on the "I" side, the FP-2000 is turned on,
and the FT-2000D is placed in the "standby" state.
If the FP-2000 main power switch is not turned
on, it is not possible to turn on the FT-2000D trans-
ceiver. For more details about the main power
switch location on the FP-2000, please see the dis-
cussion on page 34.
If you press this switch momentarily while the trans-
ceiver is turned on, the transceiver's audio will be
muted for three seconds.
Page 16
C
ONTROLS
& S
WITCHES
MOX Switch
Pressing this button engages the PTT (Push to Talk)
circuit, to activate the transmitter (the LED inside this
button will glow red). It must be turned off (the red
LED will be off) for reception. This button replicates
the action of the Push to Talk (PTT) switch on the mi-
crophone. When engaging the [ MOX ] button (the LED
inside this button glows red) or otherwise causing a
transmission to be started, be certain you have either
an antenna or 50-Ohm dummy load connected to the
selected Antenna jack.
FT-2000D O M