Resetting The Microprocessor; Resetting Memories (Only); Menu Resetting; Full Reset - Yaesu FT-2000 Operating Manual

R M
Use this procedure to reset (clear out) the Memory chan-
nels previously stored, without affecting any configura-
tion changes you may have made to the Menu settings.
1. Press the front panel's [ POWER ] switch to turn the
transceiver off.
2. Press and hold in the [ A M ] button; while holding it
in, press and hold in the front panel's [ POWER ] switch
to turn the transceiver on. Once the transceiver comes
on, you may release the [ A M ] button.
M R
Use this procedure to restore the Menu settings to their
factory defaults, without affecting the memories you have
programmed.
1. Press the front panel's [ POWER ] switch to turn the
transceiver off.
2. Press and hold in the [ MENU ] button; while holding it
in, press and hold in the front panel's [ POWER ] switch
to turn the transceiver on. Once the transceiver comes
on, you may release the [ MENU ] button.
F R
Use this procedure to restore all Menu and Memory set-
tings to their original factory defaults. All Memories will
be cleared out by this procedure.
1. Press the front panel's [ POWER ] switch to turn the
transceiver off.
2. Press and hold in the [ FAST ] and [ LOCK ] buttons;
while holding them in, press and hold in the front
panel's [ POWER ] switch to turn the transceiver on.
Once the transceiver comes on, you may release the
other two switches.
I N
When the optional DMU-2000 is connected and is
turned on the [ POWER ] switch, the DMU-2000's data
is also reset when perform the full reset of the FT-
2000D.
When the optional RF uTUNE Kit is used, perform
the full reset of the FT-2000D after taking the optional
RF µTUNE Kit off.
FT-2000D O
R
ESETTING THE
O
M
B
EFORE
M
ICROPROCESSOR
[ POWER ] button
[ POWER ] button
[ POWER ] button
Y B
OU EGIN
[ A M ] button
[ MENU ] button
[ FAST ] button
[ LOCK ] button
Page 7