Transmitter Convenience Features; Voice Memory - Yaesu FT-2000 Operating Manual

T
RANSMITTER
You may utilize the Voice Memory capability of the FT-2000D for repetitive messages. The Voice Memory system in-
cludes four memories capable of storing up to 20 seconds of voice audio each. The maximum that any memory can hold is
20 seconds.
Recording Your Own Voice in Memory
1. Select the LSB, USB, AM, or FM mode using the front
panel [ MODE ] buttons.
2. Press the [ F5 ( MEM )] button. A blinking "
will appear in the display.
3. Within five seconds of pressing the [ F5 ( MEM )] but-
ton, press any of the buttons numbered [ F1 ( CH-1 )]
through [ F4 ( CH-4 )] to select that memory storage reg-
ister. If you do not press the PTT switch (see next step)
within five seconds, the memory storage process will
be cancelled.
4. Press the microphone's PTT switch momentarily, the
" " icon will glow steadily, and recording will
begin.
5. Speak into the microphone in a normal voice level to
record the message (such as "CQ DX, CQ DX, this is
W 6 Delta X-Ray Charlie, W 6 Delta X-Ray Charlie,
Over"). Remember that the time limit for recording
any message is 20 seconds.
6. Press the [ F5 ( MEM )] button to terminate the message
storage process.
Page 76
C
ONVENIENCE
V M
OICE EMORY SSB/AM/FM M
" icon
[ MOX ] Button [ BK-IN ] Button
[ F5 ( MEM )] Button
[ F1 ( CH-1 )] ~ [ F4 ( CH-4 )] Button
F
EATURES
Checking Your Recording
1. Be sure that the front panel [ MOX ] button is "Off"
(the LED imbedded in the switch is must be off).
2. Press the [ F1 ( CH-1 )] ~ [ F4 ( CH-4 )] button (which-
ever one you just recorded in), and you will hear the
contents of the voice memory you just recorded.
A :
You may adjust the playback level of the recording via
Menu item "015 dUS RX LVL."
Transmitting the Recorded Message
1. Select the LSB, USB, AM, or FM mode using the front
panel [ MODE ] buttons.
2. Press the front panel's [ BK-IN ] button.
3. Press the [ F1 ( CH-1 )] ~ [ F4 ( CH-4 )] button, depend-
ing on which memory register's message you wish to
transmit. If you hit the key again during playback, the
message will be terminated.
A :
You may adjust the transmit (audio) level of the recording
via Menu item "016 dUS TX LVL."
FT-2000D O M