Memory Groups; Memory Group Assignment; Choosing The Desired Memory Group - Yaesu FT DX 9000MP Operation Manual

M M M M M G G G G G
EMOR EMOR EMOR Y Y Y Y Y R R R R R OUPS OUPS OUPS OUPS
EMOR EMOR OUPS
1. Press the [ MNU ] key to enter the Menu mode.
2. Rotate the [ MAIN Tuning Dial ] knob to select Menu
item "GENERAL 038 MEM GROUP".
Rotate the [ CLAR/VFO-B ] knob to set this Menu item
to "ENABLE" (the default setting is "DISABLE").
3. Press and hold in the [ MNU ] key for two seconds to
save the new setting and exit. Operation will now be
restricted to the six Memory Groups.
To cancel Memory Group operation, repeat steps (1)
through (3) above, choosing "DISABLE" in step (2).
You may recall memories just within a particular Memory Group, if desired.
1. Press the [ V/M ] key, if necessary, to enter the Memory
mode.
2. Press and hold in the [ MCH/GRP ] key (below and to
the left of the [ CLAR/VFO-B ] knob for two seconds.
The imbedded LED inside the switch will light up.
3. Rotate the [ CLAR/VFO-B ] knob to select the desired
Memory Group.
Page 126
M G
EMORY ROUP
[MAIN Tuning Dial] knob
C D
HOOSING THE ESIRED
A
SSIGNMENT
VDD
[CLAR/VFO-B] Knob
A A A A A
D D D D D VICE VICE VICE VICE VICE
Note that for the PMS memory group, the PMS
memories "P1L" through "P9U" will be so desig-
nated, so as to avoid confusion.
Memory Channel Number
Groups Memory "OFF"
01 ~ 19
20 ~ 39
40 ~ 59
60 ~ 79
80 ~ 99
P-1L/1U ~ P-9L/9U
M G
EMORY ROUP
VDD
[V/M] Switch [MCH-GRP] Switch
To exit from Memory Group operation, press and hold in
the [ MCH/GRP ] key for two seconds once more.
A A A A A
D D D D D VICE VICE VICE VICE
VICE
You will now be operating using memories only
within the selected Memory Group.
If no channels have been assigned to a particu-
lar Memory Group, you will not have access to
that Group.
FT 9000MP O
DX
BIAS TEMP SWR
[MNU] Switch
Groups Memory "ON"
1-01 ~ 1-19
2-01 ~ 2-20
3-01 ~ 3-20
4-01 ~ 4-20
5-01 ~ 5-20
P-1L/1U ~ P-9L/9U
BIAS TEMP SWR
[CLAR/VFO-B] Knob
M
PERATION ANUAL