Fps-9000H Rear Panel; Cooling Fan - Yaesu FT DX 9000MP Operation Manual

Cooling Fan

This cooling fan provides ventilation for the power
supply circuitry. When the main power switch is turned
on, the fan will be engaged.
AUDIO Jack
INPUT A
This jack connects to the FT
SPKR A jack.
The INPUT A terminal accepts audio input from
the transceiver's Main (VFO-A) receiver.
When the cable from INPUT A is connected to the
radio's EXT SPKR A jack, the internal "A" speaker
in the transceiver will be cut off automatically.
This jack is gold-plated, for high performance.
INPUT B
This jack connects to the FT
SPKR B jack.
The INPUT B terminal accepts audio input from
the transceiver's Main (VFO-B) receiver.
When the cable from INPUT B is connected to the
radio's EXT SPKR A jack, the internal "B" speaker
in the transceiver will be cut off automatically.
This jack is gold-plated, for high performance.
OUTPUT
This is an audio output terminal that may be used
for tape recordings and other purposes.
The audio delivered from the OUTPUT jack is af-
fected by the high- and low-cut filters, and while
the audio normally is mixed (VFO-A/B), the
[ MUTE ] switches on the front panel allow you to
disable either the "A" or "B" receiver, so that only
one receiver's audio is passed to the OUTPUT jack.
Because the audio at the OUTPUT jack is affected
by the transceiver's [ AF GAIN ] control, you can
use that control to set the optimum audio output
level for the intended purpose.
This jack is gold-plated, for high performance.
FT 9000MP O
DX PERATION
9000MP's EXT
DX
9000MP's EXT
DX
M
ANUAL
FPS-9000H R FPS-9000H R
FPS-9000H R
FPS-9000H R FPS-9000H R
BREAKER Switch
The circuit breaker will trip automatically if an over-
current or other potentially-dangerous anomaly is de-
tected.
A A A A A
:
D D D D D VICE VICE VICE VICE VICE
If the breaker trips, please inspect the transceiver and
power supply to see if the problem can be found. Once
you are satisfied that nothing obvious is wrong, push
the breaker switch in until you hear a "click." This
will reset the breaker.
AC Power Cable (Input)
This is the input port for AC voltage. The FPS-9000H
uses a "universal" input from 100 to 240 Volts AC.
Power consumption is as described below:
AC Input voltage: AC100 ~ 240V (50-60Hz)
Current Consumption: 13.2A ~ 5.2A
DC Power Cable (Output)
This is the DC output cable from the power supply,
and it should be connected to the appropriate jack on
the rear panel of the FT 9000MP. The DC output
DX
is as described below:
50 Volt, 24 Amps (MAX)
13.8 Volt, 5 Amps (MAX)
5 Volt, 7 Amps (MAX)
N N N N N
:
O O O O O TE TE TE
TE TE
Please be sure that both the transceiver's front panel
[ POWER ] switch and the FPS-9000H's main power
switch are both turned off any time you plug in or
unplug any power cable to/from the FPS-9000H. This
will avoid the possibility of possibly-damaging spikes
and/or electrical shock.
P P P P P
EAR EAR ANEL ANEL
EAR EAR EAR ANEL ANEL ANEL
Page 41