Cw Delay Time Setting - Yaesu FT DX 9000MP Operation Manual

CW C CW C CW C
CW C CW C
ONVENIENCE ONVENIENCE ONVENIENCE
ONVENIENCE ONVENIENCE
During semi-break-in (not QSK) operation, the hang time of the transmitter, after you have finished sending, may be
adjusted to a comfortable value consistent with your sending speed. This is the functional equivalent to the "VOX Delay"
adjustment used on voice modes; however, this is an independent adjustment used on CW, so you don't have to change the
delay when changing from Voice to CW.
The delay may be varied anywhere between 0 seconds ( [ CW DELAY ] knob set fully counter-clockwise) to 5 seconds (fully
clockwise).
[CW DELAY] Knob
[BK-IN/SPOT] Switch
1. Press the [ BK-IN/SPOT ] key momentarily to enable
CW transmission (Menu item "MODE-CW 052 CW
BK-IN" must be set to "SEMI").
2. Start sending, and adjust the [ CW DELAY ] knob so
that the hang time is as you prefer for comfortable
operation.
A A A A A
D D D D D VICE VICE VICE VICE VICE
The Sub band (VFO-B) frequency display will
show the hang time of the CW "VOX" circuit for
53seconds whenever the [ CW DELAY ] knob is
turned.
You may disable this feature (displaying the hang
time of the CW "VOX" circuit) via Menu item
"DISPLAY 022 LEVEL INDICATOR." See page
148 for details.
Page 114
F F F F F
EA EA EA EA EA TURES TURES TURES TURES
TURES
CW D T
ELAY
S
IME ETTING
Q Q Q Q Q
UICK UICK
UICK UICK UICK
The CW Delay feature is the functional equivalent
to the "VOX Delay" adjustment used on voice
modes; however, this is an independent adjustment
used on CW, so you don't have to change the delay
when changing from Voice to CW.
FT 9000MP O
DX
VDD BIAS TEMP SWR
P P P P P
OINT OINT
OINT OINT OINT
M
PERATION ANUAL