Storing An Algorithm - DigiTech Artist GSP-2101 Owner's Manual

Section 4 - Algorithm Usage
• After linking all the FX Modules correctly, press the [STORE] button. After renaming
our new Algorithm (optional), press [STORE] again to compile the Algorithm into
something we can use.
The new Algorithm is now loaded in the currently selected Program. Check to make
sure that the master Wet to Dry mixer is set to All Wet. After you tweak up the
effect's parameters (to get the sound just right), use the [STORE] button to save your
new sound.
Congratulations! You are now officially a GSP-2101 Artist power user!
PPC-210 USERS ONLY:
Because the PPC-210 adds a second S-DISC to your GSP-2101, it is possible to link effects
not only in the normal ways (series, parallel or any combination of series/parallel), but across
S-DISCs as well. This means that any of the outputs from Modules residing in S-DISC 1
can be routed to any of the inputs of Modules residing in S-DISC 2, and vice versa. There
are limits on the number of these cross-linkages however (the average is about 10 in each
direction, depending on memory constraints), so we recommend you keep them to a mini-
mum. It's also easier and less confusing to build a signal path straight through S-DISC 1
before proceeding to S-DISC 2. Also, AutoLink™ will only perform one cross-link, and
only at the end of the S-DISC 1 signal path (between S-DISC 1 and S-DISC 2).
REMEMBER: Seamless Program changes will not occur when switching to or away
Storing an Algorithm: Once the Modules of an Algorithm are Linked, you must save the
Algorithm to retain your changes. This is done with the [STORE] button (in the Edit section of
the front panel). Do not exit Link mode to store Algorithms.
To store an Algorithm in memory, do the following:
• From Link mode, press the [STORE] button once. If the currently selected Algorithm
name is already in use, the display will briefly read:
after which you are automatically placed in Name mode.
• Give the Algorithm a new name (using the naming procedures covered on pg. 16) and
press the [STORE] key again. The display briefly reads:
after which you are automatically returned to the Algorithm select screen.
58
from a Program that uses a dual S-DISC Algorithm.
Algorithm name is
already in use
**** SAVING
**** ALG
/
****
****
GSP-2101 Artist Owner's Manual